配置 Grbl

Grbl has a system ‘$’-command to tweak the settings and trigger runtime commands. Connect to Grbl using the serial terminal of your choice (baud rate 9600 unless you changed that in config.h) as 8-N-1 (8-bits, no parity, and 1-stop bit.) Once connected you should get the Grbl-prompt, which looks like this:

Grbl 有一个系统“$” – 命令来调整设置和触发运行命令。使用您所选择的串行终端连接 Grbl(默认 波特率 9600 除非你在 config.h 更改过)8-N-1(8 位,无奇偶校验,1 停止位)一旦连接你会收到 Grbl 提示,就像这样:

Grbl 0.8c ['$' for help]

Type $ and press enter. You should not see any local echo of the $ and enter, but Grbl should respond with a help message:

输入 $ 并按回车键。Grbl 会返回一些帮助信息: 继续阅读“配置 Grbl”